Measurements

In bare feet, measure from the floor to the top of your head. Photo not required.

With your arms stretched out, at shoulder height, measure from wrist bone to wrist bone across your chest. Keep the measuring tape as close to your arms as possible. The start and end positions of your measurement should not go past or cover your wrist bone/joint.

Photo Requirements: Wear a shirt that allows us to see your wrist bones. Show the entire wingspan and make sure the measuring tape numbers are visible.

Measure from shoulder to shoulder across the front of your body with your arms at your side. The shoulder measuring point is a bony protrusion where your arm meets the body.

Photo Requirements: Wearing a fitted shirt, or ideally something that shows your shoulders. Lay the measuring tape across the front of your chest, as close to your shoulders and chest as possible.

With your arm bent at the elbow 90 degrees, measure from the bony protrusion at the shoulder, where your arm meets the body, to the outside of your bent elbow.

Photo Requirements: Show the entire length of the measuring tape, from start to end. Wear a fitted shirt or something that allows us to clearly see the definition in your arm.

With your arm bent at the elbow, place your forearm on a flat surface with your palm facing up. Measure from the inside of the elbow crook to your wrist bone. You want the start of the measuring tape snug against the crease/fold at your elbow. The measurement should not go past or cover your wrist bone/joint.

Photo Requirement: Please wear a shirt that allows us to see your forearm clearly.

With your arm bent at the elbow, place your forearm on a flat surface with your palm facing down. Use a piece of paper to mark the end of your elbow joint. Measure from the edge of the paper to your wrist bone. The measurement should not go past or cover your wrist bone/joint.

Photo Requirement: Please wear a shirt that allows us to see your forearm and the paper clearly.

Place the start of the measuring tape at your navel (belly button), and wrap it around your waist. A photo is not required.

Place the start of the measuring tape between your collar bones where the hard bone transitions to the soft tissue of your throat. Measure to your navel (belly button).

Photo Requirements: Show the entire length of the measuring tape, from start to end. Please point to your belly button if you are wearing a shirt.

Place the start of the measuring tape at your adams apple, and wrap it around your neck. Photo not required.

Measure your chest protector from the base of the neck, below the collar, to the bottom of belly padding. If you have a built-in collar, do not include the collar in the measurement. Start the measurement where the collar attaches to the body. It's easiest to take this measurement with your chest and arm protector lying on the ground.

Do not include the built-in neck protector or mini neck collar in your measurement.

Photo Requirements: Show the entire length of the measuring tape, from start to end.

In bare feet, measure from the floor to the top of your head. Photo not required.

Place the start of the measuring tape at your navel (belly button), and wrap it around your waist. A photo is not required.

Place the tape measure around the largest part of your hips/bum.

Place one end of the measuring tape against your crotch (as high as it will go), and then measure to the center of your knee.

Photo Requirements: Show the entire length of the measuring tape, from start to end. Please wear shorts so we can see your knee cap.

Measure your pants from the collar attachment to the bottom of the pant. Hang your pants, or pull the pant taught (pull the top and the bottom away from each other) while taking the measurement to get the most accurate value.

Measure the external circumference of your pants at the collar attachment. The easiest way to take this measurement is to stand in front of a mirror while wearing your goalie pants, wrap the tape measure around your pant waist, making sure to keep it at the point where the collar attaches to the body.

Measure the external circumference of your pant leg opening.

In bare feet, measure from the floor to the top of your head. Photo not required.

With your knee slightly bent, measure from the floor to the center of your knee, on the outside of your leg.

Place one end of the measuring tape against your crotch (as high as it will go), and then measure to the center of your knee.

Photo Requirements: Show the entire length of the measuring tape, from start to end. Please wear shorts so we can see your knee cap.

Measure from the toe edge of your pad to the boot crease.

Measure from the boot crease to the top edge of your pad.

Measure from the boot crease to the first knee roll. For pads without a knee roll, measure the inside leg channel, from boot crease to the start of the knee cradle.

Measure from the first knee roll to the last. For pads without knee rolls, measure the inside leg channel, from the start of the knee cradle to the end of the knee cradle.

Measure across your palm, approximately 1" (2.5cm) below your joint.

Measure from the base of your hand to the tip of your middle finger.

Measure the width of your middle finger.

Place the start of the measuring tape at your navel (belly button), and wrap it around your waist. A photo is not required.

Place the tape measure around the largest part of your hips/bum.

Put on your jock and measure the circumference of the waistband. The waist band will typically be in the same location as the waist of your pants.

Standing on the ground, measure 6" (15cm) from the center of your knee towards your thigh. At this point on your thigh, measure the circumference around your leg.

Standing on the ground, measure 3" (7.5cm) from the center of your knee towards your shin. At this point on your shin, measure the circumference around your leg.

While wearing your chest protector, measure from shoulder to shoulder.

Place a measuring tape around the circumference of the largest part of your elbow protector.

While wearing your chest protector, place the start of the measuring tape at the collar and place the other end of the measuring tape at the length you desire for your jersey.

Place the start of the measuring tape at your navel (belly button), and wrap it around your waist. A photo is not required.